3 Feb This standard is issued under the fixed designation D; the 1 This test method is under the jurisdiction of ASTM Committee D18 on Soil. ASTM D Standard Test Method for Electronic. Friction Cone and Piezocone Penetration Testing of. Soils. Recently updated standard describing. 1 Jan ASTM D Standard Test Method for Electronic Friction Cone and Piezocone Penetration Testing of Soils. standard by ASTM.
|Published (Last):||6 June 2005|
|PDF File Size:||1.49 Mb|
|ePub File Size:||20.68 Mb|
|Price:||Free* [*Free Regsitration Required]|
Porewater pressure dissipation, after a push, can also be monitored for correlation to time rate of consolidation and permeability. Field tests using mechanical-type asstm are covered elsewhere by Test Method D This astm d5778 is primarily for use in coring through shallow 0. Astm d5778 not show this again.
You have successfully saved to your supplier list. Active view current version of standard. When properly performed at suitable sites, the test provides a rapid means for determining astm d5778 conditions.
Cone tip projected area is commonly referred to in square centimetres for convenience. Continue shopping Proceed to checkout. Pore pressure dissipation, after a push, astm d5778 also be monitored for correlation to soil compressibility and permeability.
However, many of the procedural requirements herein could apply to those penetrometers. However, many of the procedural requirements herein could apply to those penetrometers. Cone tip projected area is commonly referred to in square centimetres for convenience. astm d5778
The values stated in each system are not equivalents; therefore, each system must be used independently of the other. The use of an inclinometer is highly recommended since it will astm d5778 information on potentially damaging situations during the sounding astm d5778. When properly performed at suitable sites, the test provides a rapid means for determining subsurface conditions. Tests performed using this test method provide a detailed record of cone resistance which is useful for evaluation of site stratigraphy, homogeneity and depth to firm layers, voids or cavities, and other discontinuities.
Users of this standard are cautioned that compliance with Practice D does not in itself assure reliable results. Note 3—The quality of the results produced by this standard is dependent on the competence of the personal performing the test, and the suitability of the equipment and facilities used. Are you sure you want to unsubscribe astm d5778 It is the responsibility astm d5778 the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations astm d5778 to use.
The printed version is available at half price when you buy the electronic version. Within Section 13 on Astm d5778, SI units are considered the standard.
It is the responsibility of the user astm d5778 this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Link to Active This link will always route to the current Active version of the standard.
International Standards for CPT – Gouda Geo-Equipment BV
Du abonnerer allerede dette emne. It was not possible to unsubscribe – please try again later or astm d5778 the Danish Standard Please make sure you astm d5778 logged in. Within Section 13 on Calculations, SI metric units are considered the standard.
Other commonly used units such as the inch-pound system are shown in brackets. Username or password invalid. The use of an inclinometer is highly recommended since it will provide information on potentially damaging situations during the sounding process.